We pay shipping!
Smaller size! Same performance! Lower price!
Maker-X Dual drive V4(Includes heat sink) x 1
XT60+ Plug (Male and female) x 1
PH2.0MM 6Pin JST wires x 3
Micro USB data line x 1
- Hardware: V 4.2
- Firmware: V3.63
- Voltage: 8V - 60V (2S to 12S LiPo safe).
- Voltage spike should not exceed 60V!
- Current: Continuous 40A（single）, maximum instantaneous pulse 100A（single）. The value depends on the temperature around the equipment, heat dissipation and air circulation!
- 5V 1.5A Output
- 3.3V 1A Output
- Mode: DC, BLDC, FOC (sinusoidal)
- Supported sensors: ABI, HALL, AS5047
- Size: Long * Wide * High 76*60*18.5
Measure the current and voltage of 2 phases
- Regenerative braking
- Traction control (single and double settings)
- Sensorless or Sensorless Operations + Mixed Mode
- Configurable RPM, Current, Voltage and Power Limitations
- Input source: PPM, simulation, NRF Nyko Kama Nunchuck
- Communication Port: USB, CAN, UART
- Throttle Curve and Slope of All Input Sources
- Separate acceleration and brake throttle curves
- Seamless Four Quadrant Operation
- Motor speed, ampere hour, watt hour count
- Real-time data analysis and readout through communication ports.
- Adjustable protection:
- Low input voltage
- High input voltage
- High motor current
- High input current
- High regenerative braking current (motor and input limit separately)
- High Speed (Individual Restriction in Each Direction)
- Overtemperature protection (MOSFET and motor)